Removable Insert Box for the Tech OT-MC. The Tech OT-MC comes with one Insert Box that is removable and can be positioned in 5 different locations in the center injection molded box. Each box has a rubber cap, and the box
can be used to store parts, tools and other accessories. The center injection molded box can store up to Three Insert Boxes.
Specifications
- Height- 9in
- Length- 4in
- Width- 2in
- Rubber Cap
- Insert Box is designed to specifically fit the grooves of the Tech OT-MC center injection molded box
Keep the Zippers Clean and Lubricated
Over time, dirt and grit will clog the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
Protect Any sharp object or heat source is capable of permanently damaging the zippers.
Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
Don’t Overstuff the Bag
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution! The Zippers From Sharp Objects and/or Excessive Heat