With 2 Exterior shop walls of tool storage and open access to interior tool pockets, the MB-TT with non-marking rubber bottom is designed for Builders, General Contractors or any tradesman or technician to store hand tools on the inside pockets and bulk storage capacity in the middle. The bags is also designed to accommodate Boat Builders and Shipwrights to store, carry and access all of their tools.
Specifications
- Height (HH): 13in (33cm)
- Width (W): 16.5in (42cm)
- Depth (D): 7in (18cm)
- Weight (empty): 7lbs (3kg)
- Max Payload: 40lbs (18kg)
- Internal Volume: 1450in3 (24L)
Capacity
- 2 Interior, Removable Pocket Panel Sleeves, Totaling 18 Pockets
- 32 Exterior Vertical Tool Pockets
- Polypropylene bottom over-molded with non-marking TPR Rubber
- Stainless Steel Tape Measure Clip
Build
- Polyester Canvas Body Fabric
- Leather Grips and Trim
Keep the Zippers Clean and Lubricated
Over time, dirt and grit will clog the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
Protect the Zippers From Sharp Objects and/or Excessive Heat
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
Don’t Overstuff the Bag
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!