Titebond All Weather Subfloor Adhesive is the ideal choice for subfloor installations. It is designed for particleboard, OSB, engineered lumber and wet, frozen and treated lumber. It offers a strong initial tack, provides superior strength and remains permanently flexible. Titebond All Weather fills gaps and irregularities between materials and provides a more solid backup surface. It reduces the amount of nailing and helps eliminate squeaky floors. It also works extremely well in colder temperatures.
Features
- Works extremely well in cooler temperatures
- Ideal for plywood, particleboard and OSB
- Ideal for wet, frozen and ACA & CCA treated lumber
- Fills irregularities between materials to provide a more solid backup surface
- Exceeds the requirements of CAN/CGSB-71.25M and CAN/CGSB-71.26M specifications
Application Guidelines
- Application Temperature: 0°F. to 100°F.
- Service Temperature Range: -20°F. to 120°F.
- Method of Application: Cartridge/caulking gun
- Working Surfaces: Surfaces to be bonded should be clean and free from excessive oil, grease, water, dirt or any other material that may deter adhesion. Apply adhesive to each piece of furring, studs or floor joists to be covered. When bonding subfloors or wet, frozen and treated lumber, nail or screw each sheet as recommended by the American Plywood Association.
- Working Time: Approximately 10-20 minutes for a 1/4in bead
- Cleanup: Scrape off dried excess with a putty knife. Remove residue with mineral spirits or equivalent solvent. Follow solvent vendor's precautions when using solvents. NOTE: Test solvent on an out-of-the-way area to make sure it will not mar or attack the surface.
Physical Properties
- Type: Synthetic elastomeric polymer
- Calculated VOC: 389 g/L
- State : Medium-viscosity mastic
- Weight Per Gallon : 9.81 lbs.
- Color : Light tan
- Flashpoint : < 0°F.
- Solids : 67%
- Freeze/thaw Stability : Will not freeze
- Viscosity : 130,000 cps
- Storage Life : 18 months in tightly closed containers at 75°F.
Limitations
Titebond All Weather Subfloor Adhesive is not designed for continuous submersion or for use on polystyrene foams. For polystyrene foam, tub surrounds and most other plastics, we recommend Titebond Interior/Exterior Construction Adhesive.