The PS-HDL6R is a dual powered LED head torch, powered by the included USB type-C rechargeable lithium battery or can be run on 3 AAA’s using the included battery cartridge. It also comes with a 3M VHB adhesive helmet mount to attach to hardhats, a silicone lined non-slip headband and a high quality 1m USB-C charging cable. Its IPX6 waterproof rated so great for working outdoors and has a powerful 350 lumen output from its high powered SMD LEDs and can be dimmed 3 times to conserve battery. The headlight also has a retractable light shield to angle the light down to stop blinding onlookers!
Features:
- High-power 350 Lumen white SMD LEDs, 6500k
- Super wide flood of light
- Powerful rechargeable lithium battery
- With 3 x AAA battery cartridge
- Anti-dazzle retractable light shield
- 45Degree Rotational head
- IPX6 water resistant
- Fully adjustable non-slip silicone headband
- 3M VHB Helmet mount included
- USB Type-C charging - 4 hours
- 1m Charging Cable included
Specifications:
- Weight(g) : 130
- Dimensions (mm) : 65.00 x 50.00 x 45.00
- Lumens : 350
- Runtime (H) : 47
- Beam Distance (M) : 27.00
- IP Rating : IPX6
- Battery : 3.7v Li-Po 1800mAh
Operation:
- Pull out the anti-dazzle shield to reveal switch. Switch Sequence - HIGH > MED > LOW > FLASH > OFF (If left in any mode for 3 seconds, next press will turn OFF
Battery Installation:
- Open the headtorch battery compartment by very gently lifting the clasp on the top of the headtorch.
- Insert either the Unilite Li-Polymer battery or insert 3 x high quality AAA alkaline batteries into the battery cartridge, then insert the cartridge into the headtorch. Make sure you take note of the polarity marks to insert the correct way.
- Then close the headtorch until the clasp on the top clicks shut
Charging The Rechargeable Battery:
- Only use a USB type-C 5v cable (1m Cable included)
- Remove rechargeable battery from headtorch.
- Plug the USB-C end of the cable into the charge port on the side of the battery.
- Plug the USB end of the cable into any USB charging port (for USB plug adaptors, only use 5V max 1A output).
- Red LED indicates charging, Green LED indicates fully charged.
- Charge Time: 4 hrs