Trend LOCK JIG Lock Recessing Jig. This jig uses a set of interchangeable templates and with a router will cut the mortise and face-plate recess for popular door locks.
For most common sash mortises & dead locks, with up to 3in deep mortises and a 7/8in or 1in face-plate.
Deeper mortises can be achieved with a suitable size of auger bit.
Fast, clean & accurate results on doors 34mm to 58mm thick, even in hardwood.
Steel plates & body.
The jig requires a plunge router with a 80mm plunge, fitted with a 30mm guide bush with 6mm spigot & 12mm diameter long reach cutter.
Other sizes of template available to special order, please contact Trend Technical Support for more information.
Specifications
- Door thickness min.= 34 mm
- Door thickness max.= 58 mm
Includes templates for locks having the following face-plate dimensions
- Imperial (Metric)= Template
- 7/8 x 1/8in (22.2x156 mm)= 1
- 7/8 x 6in (22.5x152.5 mm)= 2
- 1 x 4 3/4in (25.4x121 mm)= 3
- 1 x 5in (25.4x127.5 mm)= 4
- 1 x 5 1/4in (25.4x133.5 mm)= 5
- 1 x 5 3/4in (25.4x145 mm)= 6
- 1 x 6in (25.4x153 mm)= 7
- 1 x 6in (25.4x156.5 mm)= 8
- 1 x 6 1/2in (25.4x165.5 mm)= 9
- 1 x 7in (25.4x177 mm)= 10
- 1 x 2 1/4in (25x57.5 mm)= 11
- UPPER 1 x 2 1/4in (26x56.5 mm)= 11
- LOWER 1 x 6 3/8in (25.6x162mm= 12
- Mortise Dimensions Imperial (Metric)= Template
- 5/8 x 2 7/8in (16x72 mm*+)= A
- 5/8 x 4 1/4in (16x107 mm*)= B
- 3/4 x 3 1/8in (19x78 mm*)= C
- 3/4 x 4 1/4in (19x109 mm*)= D
*These are maximum mortise length, unless radius ends are squared with a chisel.
+Note: actual size of mortise 16 x 79 mm (5/8 x 3 7/64in)
Includes
- 1 x Guide Bush Collar
- 12 x Face Plate Templates
- 4 x Mortise Templates
- 6 x Spacer Fingers