The NGX Clamp Edge System makes it faster and simpler to break down sheet material - rip and crosscut boards with clean, accurate cuts every time. NGX gives you track saw-like precision without the hefty price tag. It's never been easier to rip, crosscut, and break down material than with the all-new NGX Clamp Edge System. No more fumbling with adjustable clamp ends on opposite sides of the straight edge - the adjustable clamp is connected to the handle. Simply hook the Clamp Edge across your board, line it up with your cut, and clamp it down - all without moving your feet.
Key Features:
- Fits into NGX Clamp Edge saw guide to increase length by 50 inches
- Easily attached with metal connectors
- Made of heavy gauge, extruded aluminum for extreme durability
Technical Information:
- Product Name: BORA 50" NGX Clamp Edge Extension
- SKU: 544060
- UPC Code: 814000019463
- Item Height: 1.5 inches
- Item Length: 53 inches
- Weight: 1.50 lbs.
- Item Width: 3 inches
- Model Number: 544060
- Prop 65: Wood Dust
Connecting Extension to Clamp Edge:
- 1. Remove screws in orange end cap.
- 2. Remove end cap.
- 3. Remove 4 screws (2 on each) from metal bars protruding from extension.
- 4. Slide connector bars into end of clamp edge. (The bars will slide into the end where the orange end cap was removed)
- 5. Thread in screws loosely so that the track can move slightly.
- 6. Set clamp edge on its side, on a flat surface.
- 7. Confirm that the clamp edge is flat against the surface, then tighten screws completely.
- 8. Insert orange end cap into end of extension, and re-install screws
