Zinc Nailon anchors are low-cost, easy-to-install anchors for applications under static loads.
Features:
- Available with carbon and stainless-steel pins
- Pin and head configuration designed to make anchor tamper-resistant
- Material: Body - Die-cast Zamac 3 alloy, Pin - Carbon steel; Type 304 stainless steel
Installation:
- Drill a hole in base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to specified embedment depth, plus 1/4" for pin extension, and blow hole clean using compressed air. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling.
- Position fixture and insert Nailon anchor.
- Tap with hammer until flush with fixture, then drive pin until flush with top of head.
Caution:
- Not for use in overhead applications
- Nailon anchors are not recommended for eccentric tension (prying) loads — capacity will be greatly reduced in such applications
Specifications:
- Head Type: Mushroom Head
- Coating/Material: Carbon Steel
- Drill Bit Dia. (in.): 1/4
- Component Material, Anchor Body: Die-cast Zamac 3 alloy
- Component Material, Pin: Carbon Steel
- Box Qty.: 100
- Carton Qty.: 500
1-1/4in Zinc Nailon Pin Drive Anchor:
- Size (in.): 1-1/4
- Carton Qty.: 500
1-1/2in Zinc Nailon Pin Drive Anchor:
- Size (in.): 1-1/2
- Carton Qty.: 500