Makita's BEST 1/4in Impact Driver on the market! MADE IN JAPAN.
FINAL SALE, WHILE SUPPLIES LAST.
perimeter ring-emitting LED light
Dramatically improved visibility during work
Approximately 2.5 times brighter (compared to our conventional 18V model). Illuminance can be switched in 3 levels (strong/medium/weak).
*Among rechargeable impact drivers in Japan. *The operation panel is all lit up for the sake of photography.
Can also be used as a simple light in "light mode". Lighting time is about 1 hour.
Overall length 111 mm, weight 1.5 kg (with battery installed). Compact and lightweight body with high power and maximum tightening torque of 180 N m.
Intuitive trigger shift operation is possible from low speed to high speed range.
The gripping hand is close to the head, making it easy to push the shaft center. Reduced cam-out.
The position of the center of gravity is optimized, allowing for well-balanced tightening in all directions. In addition, interference with obstacles is reduced.
You can also check the mode operation and remaining battery capacity while holding it.
*The operation panel is all lit for shooting.
New shape bit sleeve. Ribs are provided on the edge to prevent damage even if the sleeve hits a member. *For rechargeable impact drivers in Japan.
Excellent corner hitting performance reduces cam-out. Working near walls is also comfortable.
*Minimum upward angle when tightening screws with a bit length of 65 mm and a distance of 10 mm from the wall. For impact drivers with a tightening torque of 160 Nm or more.
Slim head with no protrusion
improves corner hitting performance in all directions
Also recommended for work close to the floor or ceiling.
1 Wood mode
Start tightening slowly with the trigger fully open, and then tighten at the fastest speed with automatic transmission.
2 Bolt mode
Forward rotation/immediately fastest when the trigger is turned on. Reverse rotation/automatic stop when the nut is loosened (reverse rotation auto stop)
3 Thin plate TEK mode
After the screw penetrates, it automatically stops when an impact is detected.
4 Thick plate TEK mode
Reduces screw head jumping and cam-out.
The batting mode can be switched even while holding the grip.
By pressing two buttons at the same time, you can register one frequently used mode. Switch between the "previous used mode" and "registered mode" with the hand button.
Dustproof/waterproof plastic case (excluding accessory compartment)